SAE規格 J2836/6, 2021: Use Cases for Wireless Charging Communication for Plug-in Electric Vehicles

SAE規格 J2836-6, 2021

産業規格・仕様書  >  SAE  > 




SAE規格 J2836-6, 2021

30,470(税込)

数量

書名

SAE J2836/6 2021 Edition: Use Cases for Wireless Charging Communication for Plug-in Electric Vehicles
SAE規格 J2836/6 2021: プラグイン電気自動車のワイヤレス給電通信の事例
発行元 SAE International
発行年/月 2021年4月   
装丁 ペーパー
ページ数 20 ページ
発送予定 海外倉庫よりお取り寄せ 2週間以内に発送します
※PDF版(シングルユーザー版)をご希望のお客様は別途お問合せ下さいませ
※当ウェブ・ショップに掲載のない規格につきましては、別途お問合せ下さいませ。
※掲載の規格は、当ウェブ・ショップに掲載時点で確認できた最新版でございます。
最新の発行状況につきましては受注時に改めて確認をさせて頂きますので予めご了承下さい。

  


 

Description

 

SAE J2836/6, 2021 Edition, April 2021 - (R) Use Cases for Wireless Charging Communication for Plug-in Electric Vehicles

This SAE Information Report SAE J2836/6 establishes use cases for communication between plug-in electric vehicles and the EVSE for wireless energy transfer as specified in SAE J2954. It addresses the requirements for communications between the on-board charging system and the wireless EV supply equipment (WEVSE) in support of detection of the WEVSE, the charging process, and monitoring of the charging process.

Since the communication to the charging infrastructure and the power grid for smart charging will also be communicated by the WEVSE to the EV over the wireless interface, these requirements are also covered. However, the processes and procedures are expected to be identical to those specified for V2G communications specified in SAE J2836/1.

Where relevant, the specification notes interactions that may be required between the vehicle and vehicle operator, but does not formally specify them. Similarly, communications between the on-board charging sub-system and the on-board vehicle electronics is not formally specified in this document.

This document will be published as a set of steps. The intent of step 1 was to record as much information on “what we think works” and publish. The intent of step 2 is to provide refinement and missing pieces to step 1, with a an eye to early testing.

This version is step 2, with the aim of providing a communication protocol for home chargers.

Purpose:

The purpose of SAE J2836/6 is to specify the use cases and communications requirements that will allow access and control to magnetic field wireless power transfer (MF-WPT) for EV charging systems that comply with SAE J2954, independent of the precise technology used in implementing the wireless charging system.

SAE J2847/6 specifies the functional messaging required to support the use-cases and required in this document.

SAE J2931/6 specifies and profiles the protocols that will be used to communicate the messages between the EV and WEVSE.